HOME
APPLICATION:
This material is designed primarily as a coating for application on clean
concrete surfaces. For maximum adhesion, always etch concrete with a 25% solution
(in water) of muriatic acid, and allow to stand for 15 minutes. Then flush thoroughly
with clean water and allow to dry completely before coating. Unlike solvent-borne
sealers, WATER BASED EPOXY may be
applied to damp concrete surfaces without fear of delamination and adhesion loss.
International Concrete Repair Institute - Concrete Surface Preparation Guidelines
CAUTIONS AND
WARNINGS:
Do not take internally. Avoid contact with eyes. If solution
does come in contact with eyes, flush immediately with water and contact a physician
for medical attention. Users of organic coatings such as this material should
always wear Bureau of Mines approved paint vapor respirator, which employs two-stage
filtering/i.e. cotton and charcoal combination.
CHARACTERISTICS:
45% solid by volume
Vehicle type: amine-epoxy
Pigment type: Varies with
color
Weight per gallon: 9.2 lbs./gallon
(3.43 kilograms/3.785 liters)
Dry Time: To touch: 45-60 minutes Dry hard:8 hours To recoat:4-6 hours (to
touch)
Recommended film thickness: 3-6 mils dry (75-150 microns) Each coat
- 245 sq. ft. (22.78 M2) 6.5 mils (162.5 microns) wet (wet mil gauge recommended)
3.0 mils (75 microns) dry
Solvent: water
Gloss: full gloss
Heat-resistance:
225F (107C)
78 Sec 3.2 Inside Painting System #1
Pot Life: 6-8 hours
Mix ratio: 1 part curing agent to 8 parts base (80% of pint to 90% of a gallon)
Induction Period: 30 minutes
Minimum storage temperature: 32F (0 degrees
C)
VOC: 1.2 lbs./gallon (144 grams/liter)